Knowledge Base:  
Instructions on Using 505 Adhesive Spray
Last Updated: 02/15/2014
General Instructions on How to Use 505

  1. Protect work surface with disposable paper
  2. Shake 505 Spray & Fix can before using
  3. Hold can 12 in. / 30 cm. from fabric surface
  4. Always spray 505 Spray& Fix on the wrong side of the smaller fabric piece to be glued
  5. A light spray of 505 Spray& Fix is sufficient. A little goes a long way.
  6. Using your hand, press firmly in place to secure the piece to the larger fabric
  7. A misaligned piece may be removed and repositioned several times for 15 to 20 minutes after spraying
  8. Machine sew in place as usual
  9. Cleanup with soap and water
  10. Read label on can for storage, disposal, and first aid
  11. Test on all fabrics before using

Basting with 505

Work one half of the quilt at a time.

  1. Read general instructions
  2. Roll top back to the 1/2 way point
  3. Spray backing in 1 foot intervals for better control
  4. Press batting in place by hand, then spray batting in 1 foot intervals
  5. Press top in place by hand
  6. Repeat on opposite half of layered quilt

Embroidering with 505


  1. Read general instructions
  2. Lightly spray 505 on the stabilizing interfacing
  3. Position interfacing behind the area to be embroidered
  4. Using your hand, press in place to secure
  5. Embroider your pattern
  6. Remove excess interfacing if needed



Was this article helpful?

Comments:
 

Related Articles
 > 505 Temporary Adhesive Spray FAQs
 > Heat N Bond Lite Directions
 > Bobbin Buying Guide